Melitta Avanza F270-100 - Transport, Storage, and Disposal; Venting the Appliance; Transporting the Appliance

Transport, storage and disposal
54
GB
5. Insert the drip tray without the coee
grounds container.
6. Place the coee grounds container
beneath the Cappuccinatore.
» The Water display lights up and
requests you to remove the water
tank and insert the water lter.
7. Remove the water tank.
8. Empty the water tank.
9. Insert a new lter in the water tank (see
Fig. 19).
10. Fill the water tank.
11. Insert the water tank again.
» The Steam display lights up and
requests you to open the "valve".
12. Open the "valve".
If the appliance requests you to ll the
water tank during this procedure, close
the "valve" rst. Fill the water tank and
afterwards open the "valve".
» The lter is rinsed with water.
» Water ows into the vessel beneath
the Cappuccinatore.
» The Steam display lights up and
requests you to close the "valve".
13. Close the "valve".
» The lter programme is nished.
» The Filter display goes out.
» The appliance is ready for operation.
Permanently de-registering the water
lter
If you have removed an inserted water
lter and want to continue operating the
appliance without a water lter, deactivate
the water lter on the appliance:
1. Remove the water tank.
2. Empty the water tank.
3. Remove the water lter (see Fig. 19).
4. Fill the water tank.
5. Insert the water tank again.
6. Press the "Service" button for
more than 2seconds to call up Service
mode1.
7.  Press the "Service" button
repeatedly until the display for the Filter
function appears.
8. Press the "Coee strength" button
repeatedly until no coee beans are lit.
9. Press the "Service" button for
more than 2seconds to save the
setting and exit the service mode.
» The water lter is de-registered.
» The water hardness is reset to the
water hardness that the appliance
had stored prior to inserting a water
lter.
10. Adjust the water hardness if necessary
(see section.6.3 Setting the water hard-
ness on page45).
8 Transport, storage and
disposal
8.1 Venting the appliance
We recommend venting the appliance
when it is not used for a long period, prior
to transport and when there is a risk of
frost.
During venting, residual water is removed
from the appliance.
If you put the appliance back into opera-
tion, automatic rinsing is carried out after
switching on and the appliance vented
(see section3.6 Switching on the appliance
for the rst time on page37).
CAUTION
Outowing steam and hot steam pipe
 Do not reach into the steam that is
owing out.
 Do not touch the steam pipe during
and immediately after use. Wait until
the steam pipe has cooled down.