ENGLISH
57
8 Preparing milk froth
Prerequisite: The appliance must be ready for operation (see „Switching on
and off“ on page 52).
Place a vessel (e.g. a latte macchiato glass) under the milk canister.
• Remove the milk canister and ll it with the milk2shower milk powder.
• Place the milk canister on the magnetic holding point under the milk
shower (Fig. A, no. 13).
• Turn the rotary switch for the milk shower (Fig. A, no. 11) clockwise to
open the milk shower.
→ The symbol for the milk shower is ashing. Approximately 90 ml of hot
water ows into the milk canister and generates the milk froth. The milk froth
runs out of the milk canister into the vessel below the canister. The ow of
water stops automatically after about 90 ml.
• Turn the rotary switch for the milk shower anti-clockwise to close the
milk shower (this can also be done prematurely if you desire less milk
froth).
• Now start the coffee dispensing process, e.g. to prepare a latte
macchiato.
Heft_Lattea_EU_2_3.indd 57 09.04.2014 14:04:19
To Next Page
Loading...
