Melitta Caffeo Solo & Milk - Cleaning and Maintenance

23
EN
Setting the water hardness
The appliance includes a test strip to
determine the water hardness.
• Determine the hardness of the tap water
using the test strip.
• Switch on the appliance.
• Press the and buttons
simultaneously for longer than 2
seconds. ashes rapidly.
• Press the button to show the
menu for setting the water hardness.
illuminates.
• Set the determined water hardness by
pressing the button. The selected
water hardness is shown by the bean
symbols .
Water hardness °dH °e °fH
1:
0 - 10 0 - 13 0 - 18
2:
10 - 15 13 - 19 18-27
3:
15 - 20 19 - 25 27-36
4: ashing
> 20 > 25 > 36
• Press to conrm the selection.
Cleaning and maintenance
Warning!
– Pull the power supply plug before
cleaning.
– Never immerse the appliance in
water.
– Do not use a steam cleaner.
Daily cleaning
• Wipe the outside of the appliance with a
soft damp cloth and normal dishwashing
liquid.
• Empty the drip tray.
• Empty the coffee grounds container.
Cleaning the steam pipe
• Let the steam pipe cool down.
• Wipe the steam pipe on the outside with
a damp cloth.
• Twist off the steam pipe in the direction
shown by the arrow (Image F).
• Pull the nozzle out of the steam pipe
(Image G).
• Rinse all of the parts thoroughly with
water and dishwashing detergent if
necessary.
• Clean the nozzle with a pointed object or
a brush (Image H).
• Push the nozzle into the steam pipe.
• Twist on the steam pipe the opposite
direction as shown by the arrow
(Image F).
Cleaning the brewing unit
It is recommended to clean the brewing
unit once a week.
• Switch off the appliance and pull the
power supply plug.
• Pull off the cover 13 to the right.
BA_Solo_Milk_082016.indd 23 21.09.2016 07:23:14