Melitta Caffeo Solo & Milk - Integrated Cleaning Programme; Cleaning Phase 1; Cleaning Phase 2; Cleaning Phase 3

24
• Press and hold the red button on the
handle of the brewing unit (Image B, 1).
• Turn the handle clockwise until the stop.
• Pull the brewing unit out of the appliance
by the handle.
• Rinse the brewing unit thoroughly on all
sides with clear water. The area shown
in Image D (arrow) must be free of
coffee residues.
• Let the brewing unit drip dry.
• Remove coffee residues from the
appliance.
• Insert the brewing unit back into the
appliance, press and hold the red
button (Image B, 1) and turn the handle
counterclockwise until the stop.
• Insert the cover until it clicks in.
Integrated cleaning programme
The integrated cleaning programme (takes
about 15 minutes) removes residues and
coffee oil residues that cannot be removed
by hand. The cleaning symbol ashes
during the entire process.
The cleaning programme should be
performed every 2 months or after 200
brewed cups, however, at the latest when
is lit up.
Only use Melitta
®
cleaning tabs.
• Switch off the appliance.
• Fill the water reservoir with tap water up
to the max. mark.
• Insert the water reservoir.
• Press the and buttons
simultaneously for longer than 2
seconds. ashes, illuminates.
• Empty the drip tray and coffee grounds
container.
• Insert the drip tray without the coffee
grounds container
• Place the coffee grounds container
under outlet 2.
Cleaning phase 1 ( ):
Two rinsing processes will be performed.
When illuminates, proceed as follows:
• Remove and clean the brewing unit
("Cleaning the brewing unit", page
23).
• Put a cleaning tab in the brewing unit
(Image C).
• Insert the brewing unit ("Cleaning the
brewing unit", page 23).
Cleaning phase 2 ( ):
When illuminates, proceed as follows:
• Fill the water reservoir with tap water up
to the max. mark.
• Press the button to continue with
the cleaning programme (takes about 5
minutes).
Cleaning phase 3 ( ):
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container.
• Insert the drip tray without the coffee
grounds container
• Place the coffee grounds container
under outlet 2.
Cleaning phase 4 ( , the middle
bean is ashing):
• The cleaning programme will be
continued again and takes about 5
minutes.
When illuminates, proceed as follows:
• Empty the drip tray and coffee grounds
container and insert them in the
appliance as usual.
The cleaning programme is nished.
BA_Solo_Milk_082016.indd 24 21.09.2016 07:23:14