Melitta Caffeo Solo & Milk - Troubleshooting; Common Faults and Solutions

28
Troubleshooting
Fault Cause Measure
Coffee only ows drop-by-
drop.
Grinding neness is too ne.
Adjust the grinding neness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Coffee does not ow.
Water tank not lled or
incorrectly inserted.
Fill the water tank and make sure it is
inserted correctly.
Brewing unit is obstructed. Clean the brewing unit.
The grinder is not grinding.
The beans are not falling into
the grinder.
Tap lightly on the bean container.
Foreign objects in the grinder. Call the hotline.
Loud grinder noise Foreign objects in the grinder. Call the hotline.
Bean symbols are
ashing although the bean
container is full.
Insufcient quantity of ground
beans in the brewing chamber
Press the button or
button.
The symbol is illuminated
without a reason.
There is air in the lines inside
the appliance.
Turn the valve switch 11 clockwise
until the stop until water ows out of
the appliance.
Clean the brewing unit if necessary.
The cleaning or descaling
process was interrupted.
The power supply was
interrupted, e.g. due to a power
outage.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Not enough milk froth is
formed during the frothing
process.
The nozzle of the steam pipe is
in the wrong position.
Adjust to the proper position.
The steam pipe nozzle is dirty. Clean the nozzle.
The brewing unit can no
longer be reinserted after
removal.
The brewing unit is not properly
locked.
Check whether the handle for locking
the brewing unit is correctly engaged.
The actuator is not in the
proper position.
Switch the appliance off and then on
again. Press the and
buttons simultaneously for longer than
2 seconds. The actuator is put into
position. Then reinsert the brewing
unit and make sure it is correctly
locked into place.
The symbols for cleaning
and stand-by ash
alternately.
The brewing unit is missing or
not properly inserted.
Insert the brewing unit properly.
The brewing chamber is
overlled.
Switch off the appliance and switch
it on again using the ON/OFF button
(repeat if necessary) until standby
mode is displayed.
Continuous ashing of all
buttons
System error
Switch off the appliance and switch it
on again via the ON/OFF button
; if this does not solve the problem
send the appliance to the service
department.
BA_Solo_Milk_082016.indd 28 21.09.2016 07:23:15