Melitta Caffeo Solo & Milk - First-Time Use; Initial Setup Procedure

19
EN
Display
Illuminated
The appliance is ready
for operation.
Flashing
Appliance is heating
up or coffee is being
dispensed.
Illuminated
Change the Melitta
®
Claris
®
water lter
Flashing Filter change in process
Illuminated
Fill the water
reservoir.
Flashing Insert the water reservoir
Illuminated
Empty drip tray and cof-
fee grounds container
Flashing
Insert the drip tray and
coffee grounds container
Illuminated
1 bean: mild
2 beans: normal
3 beans: strong
Flashing
Fill bean container;
ashing stops after dis-
pensing the next coffee.
Illuminated Clean the appliance
Flashing
Integrated
cleaning programme is
running
Illuminated
Descale the
appliance
Flashing
Integrated
descaling
programme is
running
Illuminated
Steam ready
or:
There is air in the
system.
Turn the valve switch 11
clockwise until the stop
until water ows out of
the appliance.
Flashing
Steam or hot water
dispensing underway
Before using for the rst time
General information
• Only use pure water without
carbonation.
• Use the supplied test strip to determine
the hardness of the water used and set
the water hardness ("Water hardness
and lter", page 22).
Information for using for the rst
time
The appliance must be vented before
it is used for the rst time. To do so,
the appliance may only be switched on
without a Melitta
®
Claris
®
water lter and
with a completely lled water reservoir.
• Place a vessel under the steam pipe 12.
• Press the button to switch on
the appliance. illuminates on the
display.
• Turn the valve switch 11 clockwise until
the stop. ashes on the display.
Water will ow into the vessel.
• When is illuminated on the
display, turn the valve switch 11
counterclockwise until the stop.
• The appliance is ready for operation.
• After using the appliance for the rst
time, insert the Melitta
®
Claris
®
water
lter if required (see page 23).
BA_Solo_Milk_082016.indd 19 21.09.2016 07:23:13