Melitta Caffeo Solo & Milk - Appliance Startup; Preparation Steps; Setting Coffee Options; Dispensing Coffee

20
Starting up the appliance
Starting up
Warning!
Danger of re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
– Ensure that the supply voltage
corresponds to the supply voltage
specied on the identication label of
the appliance. The identication label is
located on the right side of the appliance
behind the cover (Image A, 13).
– Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualied
electrician.
– Never use damaged power cables
(damaged insulation, bare wires).
• Place the appliance on a stable, dry and
level surface with sufcient clearance (at
least 10 cm) to the sides.
• Plug the power cable into a suitable
power socket.
• Remove the lid from the bean
container 8.
• Fill the bean container with suitable
coffee beans.
• Put the lid back on.
• Lift up the lid of the water reservoir 7
and pull the water reservoir up and out
of the appliance.
• Fill the water reservoir with fresh tap
water only up to the max. mark.
• Insert the water reservoir into the
appliance.
• Place a vessel under outlet 2.
• Press the ON/OFF button to
switch the appliance on or off. The
appliance performs an automatic rinse if
necessary.
Preparation
• Fill the water reservoir with fresh water
every day. The water reservoir must
always be lled with enough water for
the operation of the appliance.
• Fill the bean container preferably with
espresso beans or bean mixtures for
fully automatic coffee machines.
Do not use any ground, glazed,
caramelised or otherwise sugar-coated
coffee beans.
Setting the dispensed quantity and
strength
• Turn the coffee quantity regulator 4 to
innitely adjust the dispensed quantity.
Regulator all the way to the left = 30 ml
per cup
Regulator all the way to the right = 220
ml per cup
• Press the button until the desired
strength is adjusted. The strength is
shown by the beans on the display 10
(from = mild to = strong).
Dispensing coffee or espresso
One or two cups can be dispensed
simultaneously.
• Switch on the appliance.
• Place one or two cups under the outlet.
• Preparing one cup: Press the
button once
• Preparing two cups: Press the
button twice.
• Press the button again to cancel the
coffee dispensing.
BA_Solo_Milk_082016.indd 20 21.09.2016 07:23:14