Melitta Caffeo Solo & Milk - Water Hardness and Filter Management; Water Filter Information; Water Filter Installation

22
Dispensing hot water
A maximum of 150 ml of hot water can be
dispensed in each process. To dispense
a larger amount of hot water, repeat the
process.
• Switch on the appliance.
• Push the outer shell of the steam pipe
up in the direction shown by the arrow
(Image K, 2).
• Hold the vessel under the steam pipe.
• Turn the valve switch 11 clockwise until
the stop. is ashing. Hot water will
ow into the vessel.
• Turn the valve switch 11
counterclockwise until the stop.
Water hardness and lter
It is important to properly set the water
hardness so that the appliance displays
the need to be descaled in due time. From
the factory, it is set at water hardness 4.
After inserting a Melitta
®
Claris
®
water
lter, it is automatically set at hardness
level 1.
Melitta
®
Claris
®
water lter
The Melitta
®
Claris
®
water lter removes
lime and other harmful substances from
the water. The water lter should be
changed every 2 months, however, at the
latest when appears on the display.
The water lter is available in specialised
shops.
Inserting the water lter
ashes during the entire changing
process.
• Put the water lter in a glass with
tap water for several minutes before
inserting it in the appliance.
• Switch off the appliance.
• Press and hold the and buttons
for approx. 3 seconds, then release.
appears on the display.
• Empty the drip tray and insert without
the coffee grounds container.
illuminates.
• Pull the water reservoir 7 up and out of
the appliance.
• Empty the water reservoir.
• Screw the water lter onto the thread at
the bottom of the water reservoir.
• Fill the water reservoir with fresh tap
water up to the max. mark.
• Insert the water reservoir into the
appliance. illuminates.
• Place the coffee grounds container
under the steam pipe 12.
• Turn the valve switch 11 clockwise until
the stop. ashes on the display.
Water will ow into the vessel.
• When is illuminated on the
display, turn the valve switch 11
counterclockwise until the stop.
• The appliance is ready for operation.
and illuminate. The water hardness
is automatically set to hardness level 1.
• Empty and insert the coffee grounds
container.
After inserting the water lter, the water
can be cloudy during the rst rinse
because excess activated carbon is
washed out of the lter. The water will then
be clear clear again.
BA_Solo_Milk_082016.indd 22 21.09.2016 07:23:14