Melitta Caffeo Solo - Function settings; Water hardness

20
Care and cleaning
Warning!
– Pull the power supply plug before
cleaning.
– Never immerse the appliance in
water.
– Do not use a steam cleaner.
Daily cleaning
• Wipe the outside of the appliance with a
soft damp cloth and normal dishwashing
liquid.
• Empty the drip tray.
• Empty the coffee grounds container.
Cleaning the brewing unit
It is recommended to clean the brewing
unit once a week.
• Switch off the appliance and pull the
power supply plug.
• Pull off the cover 11 to the right.
• Press and hold the red button on the
handle of the brewing unit (Image B, 1).
• Turn the handle clockwise until the stop.
• Pull the brewing unit out of the appliance
by the handle.
• Rinse the brewing unit thoroughly on all
sides with clear water. The area shown
in Image D (arrow) must be free of
coffee residues.
• Let the brewing unit drip dry.
• Remove coffee residues from the
appliance.
• Insert the brewing unit back into the
appliance, press and hold the red
button (Image B, 1) and turn the handle
counterclockwise until the stop.
• Insert the cover until it clicks in.
Integrated cleaning programme
The integrated cleaning programme (takes
about 15 minutes) removes residues and
coffee oil residues that cannot be removed
by hand. The cleaning symbol
ashes
during the entire process.
The cleaning programme should be
performed every 2 months or after 200
brewed cups, however, at the latest when
is ashing.
Only use Melitta
®
cleaning tabs.
• Switch off the appliance.
• Fill the water reservoir with tap water up
to the max. mark.
• Insert the water reservoir.
• Press the
and buttons
simultaneously for approx. 3 seconds.
ashes, illuminates.
• Empty the drip tray and coffee grounds
container.
• Insert the drip tray without the coffee
grounds container
• Place the coffee grounds container
under outlet 2.
Cleaning phase 1 (
):
Two rinse cycles are performed. When
illuminates, proceed as follows:
• Remove and clean the brewing unit
(„Cleaning the brewing unit“, Seite
20).
• Put a cleaning tab in the brewing unit
(Image C).
• Insert the brewing unit („Cleaning the
brewing unit“, Seite 20).
1401-BA_Solo _041114_1C.indd 20 24.11.14 16:08