ENGLISH
53
Filling the water reservoir
Flip up the lid of the water reservoir (Fig. • A, no. 7) and pull the water
reservoir up and out of the appliance.
Fill the water reservoir with fresh water to the Max. mark and re-insert it •
in the appliance.
Note
If the water reservoir runs empty during operation (e.g. during the coffee
dispensing process), the symbol for the water reservoir will be illuminated.
The current operation will be stopped and the water reservoir must be
filled before starting a new operation.
Switching on and venting
All lines in the appliance have been drained and vented in the factory. Consequently,
the first time the appliance is switched on the valve symbol
will be illuminated
after the heat-up phase and the appliance must be vented via the valve. Venting is only
necessary the first time that the appliance is started up.
Caution!
The appliance may only be vented without the Claris
®
water filter and
with a full water reservoir.
Insert the Melitta –
®
Claris
®
water filter into the appliance only after vent-
ing.
Fill the water reservoir with fresh water to the Max. mark – before vent-
ing.
Press the On/Off button • to switch the appliance on.
The standby symbol → will flash. The appliance will heat up.
After heating up the symbol for the valve will be illuminated .
Place a large vessel under the steam pipe.•
Turn the valve switch (Fig. • A, no. 11) clockwise to open the valve.
The valve symbol → will flash. Water will flow into the vessel under the
steam pipe.
To Next Page
Loading...
