60
8 Heating milk
Prerequisite: The appliance must be ready for operation.
Push the chrome-plated outer cover of the steam pipe upwards •
(Fig. J, No. 2).
Hold the vessel containing the milk under the steam pipe. Ensure that the •
tip of the steam pipe is immersed in the milk.
Press the button for steam dispensing •
.
The standby symbol → is flashing. The appliance heats up. Subsequently the
symbol for the valve will be illuminated.
Warning!
There is a risk of burn injuries and scalding due hot steam and the
hot steam pipe.
Never reach into the escaping steam. –
Never touch the steam pipe during use. –
Turn the valve switch (Fig. • A, no. 11) clockwise to open the valve.
The valve symbol → will flash. Hot steam coming out of the steam pipe will
heat the milk. You will achieve better results if you move the vessel with milk
up and down while heating.
As soon as the desired milk temperature is reached, turn the valve switch •
anticlockwise to close the valve and end the heating process.
Rinsing the steam pipe: •
Fill a vessel halfway with clean water and hold the vessel under the steam
pipe.
Ensure that the tip of the steam pipe is immersed in the water.
Open the valve for about five seconds and then close it again.
After 30 seconds, the appliance switches automatically from steam mode •
to normal operating mode. Press the button for steam dispensing
to
switch to the normal operating mode prematurely.
To Next Page
Loading...
