Melitta CaffeO Solo&milk - Setting energy-saving timer

64
Press the on/off button •
to confirm the selected water hardness cat-
egory.
All symbols in the display flash briefly for confirmation. The appliance is →
ready for operation, the standby symbol is illuminated.
Note
During the adjusting process, if you do not press a button within 60 sec-
onds the appliance automatically reverts to standby mode.
Setting the timer for energy-saving standby mode
Additional information on energy-saving stand-by mode is provided on page 62. The
timer is factory-set to level 1 (5 minutes).
Prerequisite: The appliance is ready for operation, the standby symbol
is illuminated.
Adjust the timer as follows:
Simultaneously press the button for coffee dispensing • and the but-
ton for brewing strength for more than 2 seconds.
The standby symbol → is flashing rapidly.
Press the button for coffee dispensing • twice to call up the menu
for energy-saving stand-by mode.
The symbol for the water reservoir → is illuminated.
Press the brewing strength button several times • to select from four
possible times for the timer.