is illuminated after a brief heat-up phase.
The appliance is ready for operation.
Integrated Descaling programme
The integrated descaling programme removes limescale in the interior of the ap-
pliance. It takes a total of approximately 30 minutes. The symbol for descaling
flashes during the entire process.
Prerequisite: The appliance must be switched off. Remove the Melitta
®
Claris
®
water filter - if present - from the water reservoir before descal-
ing.
Caution!
Execute the integrated descaling programme every 3 months or when –
the symbol for descaling is illuminated in the display.
Only use the Melitta –
®
decalcifying agent for automatic coffeemakers. This
decalcifying agent is precisely matched to the Melitta
®
SOLO
®
&milk.
Never use vinegar or other descaling agents. –
Run the Integrated Descaling programme as follows:
Phase 1
During Phase 1, one bean symbol is shown on the display.
1 Simultaneously press the button for steam dispensing and the On/
Off button for more than 2 seconds.
The symbol for descaling → flashes and the symbol for the drip tray is
illuminated.
2 Empty the drip tray and then re-insert it without coffee grounds contain-
er, and place the coffee grounds container under the steam pipe.
The symbol for the water reservoir → is illuminated.
3 Pull the water reservoir up and out of the appliance and empty it com-
pletely.
To Next Page
Loading...
