Melitta Cafina XT5 - Cleaning the Brewing System; Final Activities; Cleaning the Instant System

8�7�4 Cleaning the brewing system
The prompt “Cleaning agent brewing system” is shown
on the display.
Fig. 48: Cleaning tablet
1. Open the flap(1).
2. Insert a cleaning tablet into the chute.
3. Close the flap.
4. Press the “OK” button to confirm that the cleaning
tablet has been added.
͵ The machine starts the automatic cleaning process.
͵ The cleaning process takes a few minutes.
Note
The touch screen can be cleaned while the
cleaning program is running without the need
to deactivate the display for inputs beforehand
(see also chapter8.12 on page40).
The machine is then switched off or, depending on the
selection, it goes back to operational readiness mode.
8�7�5 Final activities
1. Clean the dispensing area once the automatic cleaning
process is complete (see chapter8.13 on page41).
2. If you want to continue using the machine, refill the
milk as described in chapter5.4.3 on page14.
9 The cleaning is complete.
8�8 Cleaning the instant system
Fig. 49: Opening the instant container cover
1. Open the machine door using the key(2).
2. Lift the instant container cover(1) upwards carefully.
3. Carry out the steps as described below.
There will be one or two instant containers depending on
the equipment.
Removing the mixer unit
000174
1
12
3
4
5
6
Fig. 50: Mixer unit
1. Turn the powder chute(2) upwards so that no powder
can fall out.
2. Remove the instant container(1).
Cleaning
37
39663 • 20220101
8