3. Remove the powder chute(2).
4. Repeat the steps 1 to 3 for the second instant
container if necessary.
5. Remove the tube(6) on the mixer housing and on the
beverage outlet.
6. Turn the mixer flange(5) counterclockwise until the
arrow is on the “lock open” symbol.
7. Remove the entire mixer housing (4) towards the
front.
8. Remove the cover(3).
Fig. 51: Removing the mixer wheel
9. Remove the mixer wheel(1) from the axle either by
hand or using the removal tool(2) provided.
9 The mixer unit has been removed.
Cleaning the mixer unit and powder chutes
1. Remove rough dirt with water and a brush.
2. To clean the mixer unit and powder chutes, proceed
with one of the following options:
• Clean all parts in a dishwasher at a maximum of
60°C.
• Clean all parts thoroughly with hot water and a
cleaner suitable for milk products.
͵ Rinse all parts thoroughly with clean water.
3. Dry the parts completely.
͵ To prevent the instant powder from forming
clumps, the parts must be absolutely dry.
4. Damp-clean the area around the axle.
͵ This is the area where the mixer wheel is located.
9 The mixer unit has been cleaned.
Assembling the mixer unit
Assembly is carried out by reversing the order of the
removal process.
Fig. 52: Fitting the mixer wheel
1. Insert the mixer wheel onto the axle as far as it will go.
͵ Ensure that the flattened side(1) matches up with
the arrow(2) on the mixer wheel.
000174
1
12
3
4
5
6
Fig. 53: Mixer unit
2. Refit the cover(3).
3. Fit the mixer housing(4).
38
39663 • 20220101
Cleaning
8
To Next Page
Loading...
