Melitta CI TOUCH F630-101 - Filling with water; Adjusting the outlet; Using milk

Basic operation
38
GB
Information
ū Two-cup dispensing is not possible
when using ground coee.
ū If no coee is prepared within 3
minutes of opening the ground coee
chute, the appliance switches to opera-
tion with coee beans and the ground
coee is discharged into the coee
grounds container.
4.6 Filling with water
Only use fresh, cold water without carbon
dioxide for optimum coee enjoyment.
Change the water daily.
Information
The quality of the water largely determines
the avour of the coee. Therefore, use a
water lter (see section9.8, page49 and
section9.9, page49).
1. Open the lid of the water tank and
pull the water tank upwards out of the
appliance by the handle.
2. Fill the water tank with water.
Note the maximum capacity of 1.8
litres.
3. Insert the water tank into the appliance
from above and close the lid.
4.7 Adjusting the outlet
The spout is height-adjustable. Set the
greatest possible distance between the
outlet and the vessel. Depending on the
vessel, push the outlet up or down.
4.8 Using milk
Use cooled milk for optimum coee
enjoyment.
Depending on the model, the enclosed
milk container or the milk hose and con-
ventional milk packs can be used.
Connecting the milk container
Only ll as much milk into the milk con-
tainer as will be used immediately.
11
31
32
Fig. 9: Connecting the milk container to
the appliance
1. Fill the desired amount of milk into the
milk container(32).
2. Connect the milk hose(31) to the milk
container and the connection(11) at
the spout or insert the milk hose into a
conventional milk pack.
Information
Store the lled milk container in the
refrigerator.
4.9 Emptying the drip tray and
coee grounds container
When the drip tray(10) and the coee
grounds container(9) are full, the appli-
ance requests you to empty them. The
projecting oat(18) also indicates that
the drip tray is full. Always empty both
containers.