Melitta CI TOUCH F630-101 - Cleaning milk system programme; Cleaning coffee system programme

Care and maintenance
48
GB
9.6 "Cleaning coee system"
programme
This cleaning programme is used to
remove residues and coee oil residues
with the aid of coee machine cleaning
agents.
To avoid damage to the appliance, we
recommend carrying out the cleaning pro-
gramme every 2 months or as requested
by the appliance.
Before starting the cleaning programme,
clean the brewing unit and the interior
(see section9.3, page46).
The cleaning programme takes approx-
imately 15 minutes and should not be
interrupted.
CAUTION
Contact with coee machine cleaning
agent may lead to eye and skin irritation.
 Observe the processing instructions on
the packaging of the coee machine
cleaning agent.
ATTENTION
The use of unsuitable coee machine
cleaning agents can damage the appli-
ance.
 Only use Melitta® PERFECT CLEAN
cleaning tabs for fully automatic coee
makers.
Requirement: The appliance is ready for
operation.
1. Press the "rotary switch" for 2 seconds.
» The menu appears on the display.
2. Navigate to the Care > Cleaning coee
system menu.
3. Select Start and conrm your selection.
4. Follow the further instructions on the
display up to the end of the cleaning
programme.
9.7 "Descaling" programme
The descaling programme is used to
remove limescale deposits in the interior
of the appliance with coee machine
descaling agents.
To avoid damage to the appliance, we
recommend carrying out the descaling
programme every 3 months if a water
lter is not used. On use of a water lter,
perform descaling only when requested
by the appliance.
The descaling programme takes approx-
imately 25 minutes and should not be
interrupted.
CAUTION
Contact with descaling agent may lead
to eye and skin irritation.
 Observe the processing instructions on
the packaging of the descaling agent.
ATTENTION
Use of unsuitable descaling agent may
damage the appliance.
 Only use Melitta® ANTI CALC liquid
descaling agent for fully automatic
coee makers.
 Observe the processing instructions on
the packaging of the descaling agent.
ATTENTION
A water lter may be damaged if it is
screwed in during the descaling pro-
gramme.
 Remove the water lter when the appli-
ance requests you to do so (seeFig. 18).
 Place the water lter into a vessel lled
with tap water during the descaling
programme.
 The water lter can be reinserted and
reused when the descaling programme
is complete.