Installation
Rev 1.2
Mellanox Technologies
24
Figure 9: Connect the Mounting Brackets
3. Place four caged nuts into the rack at the U level you want to install the switch.
4. While supporting the switch catch and tighten the four bolts into the caged nuts.
5. Ground the switch.
6. Plug in the power cord.
7. You can start connecting all of the cables to the switch.
5.2.3 Installation Procedure for a Side by Side Installation
Installation kit parts for a side by side installation:
The Installation kits come with enough switch mounted rails and flat head screws to install two
switches.
• 1 Two switch metal frame • Two Rail Slides
• 4 switch mounted rails • 8 pairs of caged nuts and bolts
• 24 flat head screws • 1 blank cover
To Next Page
Loading...
