Parameter Setting
Flow Control None
Step 3. Login as admin and use admin as password. On the first login, the Mellanox Onyx (MLNX-OS) configuration wizard will
start.
Step 4. To configure network attributes and other initial parameters to the system, follow the configuration wizard as shown in the
Configuration Wizard Session table below.
Configuration Wizard Session
Wizard Session Display Comments
Mellanox configuration wizard
Do you want to use the wizard for initial configuration?
yes
You must perform this configuration the first time you operate
the system or after resetting the system. Type ‘y’ and then press
<Enter>.
Step 1: Hostname? [switch-1] If you wish to accept the default hostname, press <Enter>.
Otherwise, type a different hostname and press <Enter>.
Step 2: Use DHCP on mgmt0 interface? [no] yes Perform this step to obtain an IP address for the system. (mgmt0
is the management port of the system).
If you wish the DHCP server to assign the IP address, type ‘yes’
and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked whether you
wish to use the ‘zeroconf’ configuration or not.
If you enter ‘no’ (no Zeroconf), you must enter a static IP, and
the session will continue.
Step 3: Enable IPv6? [yes] The management interface will be able to use IPv6 addresses.
If you enter "no" (no IPv6), you will automatically be referred to
Step 6.
Step 4: Enable IPv6 auto-config (SLAAC) on mgmt0
interface? [no]
This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
Step 5: Enable DHCPv6 on mgmt0 interface? [no] To enable DHCPv6 on the MGMT0 interface.
Step 6: Admin password (Press <Enter> to leave
unchanged)? <new_password>
Step 6: Confirm admin password? <new_password>
To avoid illegal access to the machine, please type a password
and then press <Enter>. Then confirm the password by re-
entering it. Note that password characters are not printed.
You have entered the following information:
<A summary of the configuration is now displayed.>
To change an answer, enter the step number to return to
or hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
The wizard displays a summary of your choices and then asks
you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the
configuration step number that you wish to return to.
Note: To re-run the configuration wizard, run the command
“configuration jump-start” in Config mode.
To Next Page
Loading...
Need help?
General
