Mellanox Technologies SX1710 - Page 8

8
Configuration
1. Connect the host PC to the Console (RJ-45) port.
2. Configure a serial termin
al program.
Parameter Settings
Baud rate 115200
Data bits 8
Stop bits 1
Parity None
Flow control None
3. Log in:
OS Username Password
MLNX-OS admin admin
ONIE
a
a. No log in is required. Press Enter to activate the Console.
, 1
- -
4. Initial configuration
a. MLNX-OS: Go through the configuration wizard. For further information, please refer to: 
http://www.mellanox.com/page/mlnx_os
b. ONIE
1
: Please refer to ONIE User Manual (www.mellanox.com-->Products--> Ethernet Switch Systems
-->SN2000 Series

For full installation instructions, go to http://www.mellanox.com/-->Products-->
Ethernet Switch Systems.
1. ONIE OS runs on top of SN2700/SX1710 switch systems only.