Mellanox Technologies SX1710 - Figure 8: Attaching the Rails to the Chassis; Figure 9: Attaching the Brackets to the Chassis

Installation Rev 1.6
Mellanox Technologies
15
Figure 8: Attaching the Rails to the Chassis
Step 3. Attach the left and right rack mount brackets (B) to the switch, by gently pushing the switch
chassis’ pins through the slider key holes, until locking occurs. Secure the system in the brack
-
ets by screwing the remaining 2 flat head Phillips screws (E) in the designated points with a
torque of 1.5±0.2 Nm. See
Figure 9.
Figure 9: Attaching the Brackets to the Chassis
Step 4. Install 8 cage nuts in the desired 1U slots of the rack: 4 cage nuts in the non-extractable side (in
the top and bottom holes only) and 4 cage nuts in the extractable side.