Mellerware 23810 - Troubleshooting and Repairs; Breakdown Analysis and Solutions

Breakdowns
Causes
Solutions
Water drips
from the
holes on the
base of the
iron when
turning on
the steam
switch (H).
Iron thermos-
tat control (J)
set to the mi-
nimum posi-
tion "·""··".
Set the thermostat
control to the
steam zone "···".
The boiler is
too full.
Remove some
water.
The boiler
is in a tilted
position.
Place it on a
horizontal sur-
face.
The iron does
not heat and
the LED (K)
does not light
up.
The switch
Switch it to
“on” (A).
Iron ther-
mostat con-
trol (J) set to
the minimum
position.
Adjust the ther-
mostat control.
Faulty power
connection.
Check the power
points.
No steam co-
mes out
when pres-
sing the
steam switch
(H).
Empty boiler. Fill the boiler
with water.
Switches (B)
and (A) are
Switch them
on.
Leak
from the
cap (F).
Cap (F) not
properly clo-
sed.
Let the boiler cool
and screw the cap
(F) to the end
again.
The boiler cap
(F) does not
unscrew easi-
ly.
There is
steam re-
maining in-
side the
boiler.
Press the steam
switch (H) to let
the steam out.
Safety valve
activated.
Go to an authori-
zed Technical
Service.
MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 6MW_EX_23810_BRAVISSIMO_PRO 2_IM.indd 6 7/15/2009 4:32:44 PM7/15/2009 4:32:44 PM