Turn on the power switch. On /
Off switch is locating below the right side of the scale. Press switch forward to
turn on the scale. If you want to turn off, press backward the switch.
Display will be show the scale capacity and will be starting self-checking.
After self-checking, display will be come to normal weighing mode.
Then you can start your operation.
Note: Initial Start Up.
Warm-up time of 15 minutes stabilizes the measured values after switching on.
Level Adjusting
Place the scale on a table.
Check the water mark. If, bubble is not center adjust the leveling feet until reach
center. Check the level when you change the location.
Connect Adaptor
To charge the battery insert the adaptor pin to jack. Adaptor
simply plug into the mains power. The scale no needs to be
turned on.
The battery should be charged for 12 hours for full capacity.
Right side of the display there is an LED to indicate the
status of battery charging. When the scale is plugged into
the mains power the internal battery will be recharged. If
the LED is green, the battery has a full charge. If it is red,
the battery is nearly discharged and if yellow, the battery is being charged.
Do not use any other type of power adaptor than the one supplied with the
scale.
Verify that the AC power socket outlet is properly protected.
Note: Please charge the battery before using the scale for the first time.
To Next Page
Loading...