EasyManua.ls Logo

MEMUP KANYON - Connecting Earphones; Battery and Charging; Default Playback Mode; Supported Music Formats

MEMUP KANYON
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
3. Connecting the earphones: insert the earphone audio pin into the player’s water proof audio extension
cable
4. Battery: the player uses built-in rechargeable-battery. You can recharge the battery via audio extension
cable jack by connecting with the USB cable
5. Play mode: the system default mode for playing music is to repeat all songs.
6. Music Format: the system supports various music formats, including MP3 and WMA.
7. USB disk: the Kanyon supports USB 2.0, and is compatible with Windows 2000 or higher without any
driver. It can also be used as a USB flash drive for your personal data.
Keys Intro
There are a total of only 4 keys on the Kanyon
1. Play/Pause/Stop
:
Play: hold down the key until the LED light is on.
Pause: a short press will pause the music (LED blinks quickly)
Stop: a longer press will stop the music playing (LED light is off)
2. Reset
: if the unit locks up for whatever reason, press the Reset Key to restart the player and to go back to
the default setting.
3. Pre/Volume -
: whilst the music is playing, a short press of this key will select the previous song, or a
longer press will reduce the volume (when the music is paused, a short press will select previous song.)
4. Nex/Volume +
: whilst the music is playing, a short press of this key will select the next song, or a longer
press will increase the volume (when the music is paused, a short press will select next song.)

Related product manuals