390
Practical hints
Where will I find ...?
Storing the spare wheel after use
If you wish to store the spare wheel after
use, carry out the following steps. Other-
wise, the spare wheel may not fit the spare
wheel well.
왘 Unscrew the valve cap from the valve
of the collapsible tire.
왘 Take the valve extractor from the
vehicle tool kit (
컄 page 388).
왘 Unscrew the valve insert from the valve
and allow the air to escape.
왘 Screw the valve insert back into the
valve.
왘 Screw the valve cap back onto the
valve.
왘 Store the spare wheel by carrying out
the steps described in “Removing the
spare wheel” (
컄 page 389) in reverse
order.
Compressing the collapsible tire
(vehicles with 19" spare wheel only)
The collapsible tire on a 19" spare wheel
must be compressed with two tensioning
straps before you can store it back in the
trunk.
왘 Extend the tensioning strap by pulling
the slider.
왘 Place tensioning strap around spare
wheel rim and collapsible tire with the
buckle facing the inside of the rim.
왘 Close the buckle.
왘 Pull the loose end of the tensioning
strap.
The tensioning strap must be pulled as
tight as possible.
!
Make sure the spare wheel is dry before
storing it.
i
It may take a few minutes for the collapsible
tire to deflate completely.
i
Vehicles with 19" spare wheel only: Before
storing the spare wheel in trunk fasten tension-
ing straps, see “Compressing the collapsible tire
(vehicles with 19" spare wheel only)”
(
컄 page 390).
i
The tensioning straps are shown in red for
illustration purposes. The tensioning straps on
the spare wheel of your vehicle are black.
To Next Page
Loading...
Need help?
General
