R
Calling up display messages
(Y page 208)
R
Checking the tire pressure electronically
(Y page 309)
R
Calling up the service due date
(Y page 276)
Settings menu
Introduction
In the SettingsSettings menu, you have the following
options:
R
Changing the instrument cluster settings
(Y page 201)
R
Changing the light settings (Y page 201)
R
Changing the vehicle settings
(Y page 203)
R
Changing the convenience settings
(Y page 203)
R
Restoring the factory settings
(Y page 204)
Instrument cluster
Selecting the unit of measurement for dis-
tance
You can determine whether the multifunction
display shows some messages in miles or
kilometers.
X
Press the = or ; button on the steer-
ing wheel to select the SettingsSettings menu.
X
Press the : or 9 button to select the
Inst. clusterInst. cluster submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Display unit Speed-/odometerDisplay unit Speed-/odometer func-
tion.
You will see the selected setting: kmkm or
MilesMiles.
X
Press the a button to save the setting.
The selected unit of measurement for dis-
tance applies to:
R
Digital speedometer in the TripTrip menu
R
Odometer and the trip odometer
R
Trip computer
R
Current consumption and the range
R
Navigation instructions in the NaviNavi menu
R
Cruise control
R
DISTRONIC PLUS
R
ASSYST PLUS service interval display
Selecting the permanent display function
You can determine whether the multifunction
display permanently shows your speed or the
outside temperature.
X
Press the = or ; button on the steer-
ing wheel to select the SettingsSettings menu.
X
Press the : or 9 button to select the
Instrument ClusterInstrument Cluster submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Permanent Display:Permanent Display: function.
You will see the selected setting OutsideOutside
TemperatureTemperature or Additional Speedome‐Additional Speedome‐
ter [km/h]ter [km/h]/AdditionalAdditional SpeedometerSpeedometer
[mph][mph].
X
Press the a button to save the setting.
i
The speed is highlighted in km/h or in
mph conversely to your speedometer.
Lights
Switching the daytime running lamps on/
off
Daytime running lamps are required by law
(Canada only). You cannot set the "daytime
running lamps" function via the on-board
computer.
Menus and submenus
201
On-board computer and displays
Z