Seat belts
96
For this reason, check regularly that the
seat belts are not damaged or dirty.
Always have damaged seat belts or seat
belts that have been subjected to a load in
an accident replaced at a qualified special-
ist workshop. Choose a qualified specialist
workshop which has the necessary special-
ist knowledge and tools for the work
required. Mercedes-Benz recommends
that you use a Mercedes-Benz Service
Centre for this purpose.
For safety reasons, Mercedes-Benz recom-
mends that you only use seat belts which
have been approved by Mercedes-Benz for
your vehicle.
1
Belt sash guide
2
Belt tongue
3
Buckle
4
Release button
Routing the belt
X
Adjust the seat and move the backrest to
an almost vertical position (Y page 77).
X
Pull the belt smoothly through belt sash
guide 1.
X
Route the belt over the centre of the shoul-
der without twisting it.
X
Engage belt tongue 2 into buckle 3.
X
If necessary, adjust the belt to the appro-
priate height (Y page 97).
X
If necessary, pull upwards on the shoulder
section of the belt to tighten the belt across
your body.
Routing the belt
X
Press release button 4 and guide belt
tongue 2 back towards belt sash guide
1.
Controls
211_AKB; 2; 5, en-GB
mkalafa, Version: 2.9.4
2008-02-29T16:57:07+01:00 - Seite 96
Dateiname: 6515_3416_02_buchblock.pdf; preflight
To Next Page
Loading...
Need help?
General
