537
Practical hints
Jump starting
The jump-start contacts are located in the
engine compartment.
1 Negative (-) terminal
2 Positive (+) terminal
3 Positive terminal cover
왘 Make sure the two vehicles do not
touch.
왘 Turn off all electrical consumers.
왘 Apply parking brake (컄 page 67).
왘 Set automatic transmission to
position P (
컄 page 191).
왘 Open the hood (컄 page 378).
왘 Remove cover from negative
terminal 1.
왘 Flip up cover 3 of positive terminal 2
in direction of arrow.
1 Negative terminal of discharged
battery
2 Positive terminal of discharged battery
4 Positive terminal of charged battery
5 Negative terminal of charged battery
왘 Connect positive terminal 2 and 4
with the jumper cable. Clamp cable to
charged battery 4 first.
왘 Start engine of the vehicle with the
charged battery and run at idle speed.
왘 Connect negative terminals 1 and 5
of the batteries with the second jumper
cable. Clamp the cable to negative
terminal 5 of the charged battery
first.
왘 Start the engine of the disabled vehi-
cle.
You can now turn on the electrical consum-
ers. Do not switch on the headlamps under
any circumstances.
왘 Remove the jumper cables first from
negative terminals 1 and 5 and then
from positive terminals 2 and 4.
You can now switch on the headlamps.
왘 Have the battery checked at the near-
est authorized Mercedes-Benz Light
Truck Center.
Warning! G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(
컄 page 528).
!
Never invert the terminal connections!
164.boo Seite 537 Freitag, 30. März 2007 12:54 12
To Next Page
Loading...
Need help?
General
