Adaptive Highbeam Assist automatically
switches between the following types of light:
R
Low beam
R
High beam
At speeds greater than 19 mph (30 km/h):
R
If no other road users are detected, the high
beam will switch on automatically.
The high beam will switch off automatically in
the following cases:
R
At speeds below 16 mph (25 km/h)
R
If other road users are detected
R
If street lighting is sufficient
%
The system's optical sensor is located
behind the windshield near the overhead
control panel.
Switching Adaptive Highbeam Assist on/off
Switching on
#
Turn the light switch to the à position.
#
Switch on the high beam using the combina‐
tion switch.
If Adaptive Highbeam Assist is activated,
the _ indicator lamp will light up on the
multifunction display.
Switching off
#
Switch off the high beam using the combina‐
tion switch.
Switching the daytime running lamps on/off
Multimedia system:
4
©
5
Settings
5
Light
5
Daytime Run. Lights
#
Switch the function on or off.
Setting the exterior lighting switch-off delay
time
Requirements:
R
The light switch is in the à position.
Multimedia system:
4
©
5
Settings
5
Light
5
Exterior Lighting Delay
#
Set the switch-off delay time.
When the vehicle engine is switched off, the
exterior lighting will be activated for the set
time.
Light and visibility
125
To Next Page
Loading...
Need help?
General
