Messages in the multifunction display
If a gearchange process has not been successful, the following messages may be displayed
in the multifunction display:
Display messages Possible causes/consequences and M Solutions
LOW RANGE Max.
Speed 40 km/h
You have been driving faster than 40 km/h. Additionally, the
indicator lamp on the button in the center console blinks.
X
Drive more slowly to carry out the gear change process.
LOW RANGE Shift to
Position N Briefly
The transmission is in position D and you are driving at below
40 km/h.
X
Shift the transmission to N to complete the gear change
process.
LOW RANGE Shifting
Canceled Please
Reactivate
The gear change process was not carried out.
X
Ensure that all gear change conditions are fulfilled and carry out
the gear change process again.
LOW RANGE Stop
Apply Parking Brake
Awarning tone also sounds. The gear change processhas notbeen
completed. LOW RANGE is in the neutral position.There is no
connection between the engine and the drive wheels.
!
Do not drive any further. You could otherwise damage the
vehicle's drive train.
X
Stop the vehicle. Take into account the road and traffic
conditions when doing this.
X
Depress the electric parking brake (Y page 180).
X
Carry out the gear change process again.
If the gear change process has been carried out, the LOW RANGE
Stop Apply Parking Brake message disappears.
ON&OFFROAD menu in the COMAND
display (vehicles with the
ON&OFFROAD package)
You can display some driving systems, driving
programs and additional information in the
COMAND display.
X
Make sure that the SmartKey is in position
2 in the ignition lock.
X
Make sure that COMAND is activated, see
the separate COMAND operating
instructions.
X
Press function button :.
The corresponding displays appearinthe
COMAND display:
R
level control
R
steering angle
R
vehicle's angle of inclination
252
Driving systems
Driving and parking
To Next Page
Loading...
Need help?
General
