EasyManuals Logo

Mercury/Mariner 3.0 MPI ECT User Manual

Default Icon
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
Section 2 - Getting to Know Your Power Package
90-8M0074347 eng OCTOBER 2012 Page 29
Four fuses protect the main power, fuel pump, ignition, and accessory circuits. Two 10‑amp fuses protect the O
2
sensors.
These fuses are located on the top of the engine, underneath the engine information plate.
Fuse locations
a - O
2
sensor fuses
b - Main power, fuel pump, ignition, and accessory fuses
A 90‑amp fuse, located on the large post of the starter solenoid, protects the engine wiring harness if an electrical overload
occurs.
mc74907-1
Engine wiring harness fuse
A 15‑amp accessory fuse is located on the rear of the engine. This fuse protects the accessory circuits.
7524
Accessory fuse
a
b
32638

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury/Mariner 3.0 MPI ECT and is the answer not in the manual?

Mercury/Mariner 3.0 MPI ECT Specifications

General IconGeneral
BrandMercury/Mariner
Model3.0 MPI ECT
CategoryEngine
LanguageEnglish