TIMING/SYNCHRONIZING/ADJUSTING
90-826883R2 JUNE 1998 Page 2C-7
ELECTRONIC SPARK ADVANCE MODELS
20/25 1994
1
/
2
THRU 1996 AND 20 JET 1994
1
/
2
THRU 1998
1. Using approved test procedure, place the outboard in “Forward” gear and check
set-up timing. (If not within specifications, adjustment will be required).
20
3040
BTDC
28192
a
b
a- Timing Mark
b- Side Shift Model Shown
WARNING
To prevent personal injury from spinning flywheel, Do Not attempt to adjust the
trigger link rod (Maximum Timing Adjustment) with engine running.
ADJUSTING SET-UP TIMING
With the engine “OFF”, snap the trigger link rod socket off ball stud and:
• Extend rod length to “Advance” timing
• Shorten rod length to “Retard” timing
Snap link rod onto ball stud, re-start the engine and check set-up timing specification.
28192
a
b
a- Trigger Link Rod (Set-up Timing Adjustment)
b- Side Shift Model Shown
To Next Page
Loading...
