MANUAL STARTER
90-826883R2 JUNE 1998 Page 8-13
3. Install starter sheave into housing aligning notches in sheave with appropriate loca-
tions on recoil spring.
57060
a
b
b
a - Sheave
b - Alignment Notches
4. Secure cam to housing with bolt. Torque bolt to 70 lb. in. (7.9 N·m).
57055
a
95
2-4-C With Teflon (92-825407A12)
b
95
95
a - Cam
b - Bolt
NOTE: If, after tighteningcam retaining bolt, sheavedoes not move freely, sheave is not
aligned properly with recoil spring retainer. Remove cam retainer bolt and check align-
ment of sheave with spring retainer.
5. Apply 2-4-C w/Teflon to edge of cam that contacts both pawls.
6. Install starter rope as outlined previously.
7. Install rewind starter as outlined previously.
To Previous Page
Loading...
