298
[SV29388(ALL)04/95]
NOTE: Your vehicle should not be driven until
some fluid has been added if the fluid
level is below the bottom hole on the
dipstick and the outside temperature is
above 50˚F (10˚C). Add only enough
fluid to bring the level above the
bottom hole.
[SV29395(ALL)04/95]
If the vehicle has not been driven and the fluid
level is above the bottom hole on the dipstick,
do not add fluid. Recheck the fluid level after
your vehicle has reached normal operating
temperature.
*
[SV29396(ALL)02/95]
Normal operating temperature is reached after
driving approximately 20 miles (32 km). The
fluid level should be within the crosshatched
area on the dipstick.
*
[SV29397(ALL)01/95]
NOTE: If the vehicle has been operated for an
extended period at high speeds, driven
in city traffic during hot weather, or
has been pulling a trailer, the vehicle
should be turned off for about 30
minutes to allow the fluid to cool
before checking.
%
*
[SV29400(ALL)01/95]
Adding Automatic Transaxle Fluid
*
[SV29410(ALL)01/95]
Before adding any fluid, be sure that the correct
type will be used. Correct type is shown on the
dipstick.
[SV29415(ALL)04/93]
Add fluid in 1/2 pint (.25L) increments through
the filler tube to bring the level within the
crosshatched area on the dipstick. If the level is
above the top hole on the dipstick, excess fluid
should be removed by a qualified technician.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995
To Next Page
Loading...
Need help?
General
