Mercury 1996 Sable

328
*
[SV42460(ALL)04/95]
2. Idle the vehicle in Drive for 40 seconds.
*
[SV42465(ALL)04/95]
3. Accelerate the vehicle to 45 mph (72 km/h)
at 1/4 to 1/2 throttle for 10 seconds.
*
[SV42471(ALL)04/95]
4. Drive the vehicle with a steady throttle at
45 mph (72 km/h) for 30 seconds.
[SV42475(ALL)04/95]
5. Idle the vehicle in drive for 40 seconds.
*
[SV42481(ALL)04/95]
6. Continue to drive the vehicle in city traffic at
speeds between 25 and 40 mph
(40-64 km/h) for 15 minutes. During the 15
minute drive cycle the following modes must
be achieved:
*
[SV42485(ALL)04/95]
a. at least 5 stop and idle modes at 10
seconds each
*
[SV42491(ALL)04/95]
b. acceleration from idles at 1/4 to 1/2
throttle position, and
*
[SV42495(ALL)04/95]
c. choose 3 different speeds to do 1.5
minute steady state throttle drives.
*
[SV42500(ALL)04/95]
7. Accelerate the vehicle up to between 45 and
60 mph (72-97 km/h). This should take
approximately 5 minutes.
*
[SV42505(ALL)04/95]
8. Drive vehicle and hold the throttle steady at
the selected speed between 45 and 60 mph
(72-97 km/h) for approximately 5 minutes.
*
[SV42510(ALL)04/95]
9. Drive the vehicle for 5 minutes at varying
speeds between 45 and 60 mph
(72-97 km/h).
*
[SV42515(ALL)04/95]
10. Bring the vehicle back to idle. Idle in drive
for 40 seconds.
*
[SV42601(ALL)04/95]
11. OBD II drive cycle has been completed.
Vehicle can be turned off when convenient.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995