To set a speed
Press SET ACCEL. For
cruise control to
operate, the cruise
control must be ON
and the vehicle speed
must be greater than
48 km/h (30 mph).
If you drive up or down a steep hill, your vehicle
speed may vary momentarily slower or faster than
the set speed. This is normal.
Cruise control cannot reduce the vehicle speed if it
increases above the set speed on a downhill. If your
vehicle speed is faster than the set speed while
driving on a downhill in Overdrive, you may want to
shift to the next lower gear to reduce your vehicle
speed.
If your vehicle slows down more than 16 km/h (10
mph) below your set speed on an uphill, your cruise
control will disengage. This is normal. Pressing
RESUME will re-engage it.
Do not use your cruise control in heavy traffic or
roads that are winding, slippery or unpaved.
To set a higher set speed
• Press and hold SET
ACCEL. Release the
control when the
desired vehicle
speed is reached or
• Press and release
SET ACCEL. Each
press will increase
the set speed by 1.6 km/h (1 mph) or
• Accelerate with your accelerator pedal, then press
and release SET ACCEL.
ON
OFF
COAST
RESUME
SET
ACCEL
ON
OFF
COAST
RESUME
SET
ACCEL
dno_tap-up-feature
Controls and features
23
To Next Page
Loading...
Need help?
General
