Maintenance and care
209
Adjusting the vertical aim
The numbers shown on the vial
indicate beam direction in degrees
up or down.
1. Make sure the vehicle is on level
ground.
2. With the hood open, locate the
bubble level vertical aim indicator,
and adjusting screw. It is visible
when viewed from the above the
rear of the headlamp.
3. Turn the vertical adjusting screw
until the bubble is centered over
the “0” reference mark on the
vertical indicator.
4. When the horizontal and vertical
indicators are set on “0”, the
headlamp are properly aimed.
31MMCen 4/13/99 2:18 PM Page 209
To Next Page
Loading...
