EasyManuals Logo

Mercury 20 EFI FourStroke Service Manual

Mercury 20 EFI FourStroke
406 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
Lubricants, Sealants, Adhesives
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Steering cable end 92-802859A 1
Start in Gear Protection
!
WARNING
Starting the engine with the drive in gear can cause serious injury or death. Never operate a boat that does not have a
neutral‑safety‑protection device.
The remote control connected to the outboard must be equipped with a start in neutral only protection device. This prevents the
engine from starting in gear.
Lifting the Outboard
Use the lifting eye on the engine.
62883
Installing Outboard
Boat Transom Height Requirement
Measure the transom height of your boat. The boat bottom should be aligned or be within
25 mm (1 in.) above the
antiventilation plate of the outboard.
a - Antiventilation plate
Installing Outboard on Transom
!
WARNING
Failure to correctly fasten the outboard could result in the outboard propelling off the boat transom resulting in property
damage,
serious injury, or death. Before operation, the outboard must be correctly installed with the required mounting
hardware.
a
27151
Outboard Installation
Page 1D-2 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017

Table of Contents

Other manuals for Mercury 20 EFI FourStroke

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 20 EFI FourStroke and is the answer not in the manual?

Mercury 20 EFI FourStroke Specifications

General IconGeneral
BrandMercury
Model20 EFI FourStroke
CategoryEngine
LanguageEnglish

Related product manuals