Mercury 2005 Mercury Mariner User Manual

• Remove the VELCRO威 pad (2)
from the storage compartment
door (3).
• Place VELCRO威 (5) on
aftermarket transmitter (6)
opposite of actuator control (8).
• Measure the thickness (4) of the
aftermarket transmitter (6).
• Remove the rubber actuator (1)
from the storage compartment
(7) by pulling the rubber actuator
(1) forward and twisting at the
same time.
Note: The length of the rubber
actuator (1) is critical. Use care
in cutting it to length. If the rubber
actuator (1) is cut too much the
aftermarket transmitter (6) will not
activate the garage door opener. If
the rubber actuator (1) is cut too
long, the storage compartment door (3) will not close properly.
Excessive force to close the storage compartment door (3) may cause
the door latch to break.
• Per the table below, cut the rubber actuator (1) to the proper length
based on the thickness (4) measured in the third step.
Approximate Thickness of Transmitter (GDO)
inches mm
Cut to Bottom of
Notch
Less Than
1/4 6.35 No Cut
7/8 22.00 Notch 2
1.0 26.00 Notch 4
1–3/16 32.00 Notch 6
• Reinstall the rubber actuator (1) in the storage compartment (7) by
twisting and pushing it back into the slot.
• Install the transmitter (6) on to storage compartment door (3)
aligning the actuator control (8) with the rubber actuator (1). Close
the storage compartment door (3) to verify proper fit. Do not force
2005 Mercury Mariner (mrn)
Owners Guide (post-2002-fmt)
USA_English (fus)
Driver Controls
54

Mercury 2005 Mercury Mariner Specifications

General

Brand	Mercury
Model	2005 Mercury Mariner
Category	Automobile
Language	English