Mercury 2005 Mercury Mariner User Manual

To reprogram the remote entry
transmitters:
1. Ensure the vehicle is
electronically unlocked.
2. Put the key in the ignition.
3. Turn the key from the 1 (LOCK)
position to 3 (RUN).
4. Cycle eight times rapidly (within
10 seconds) between the 1 (LOCK)
position and 3 (RUN). Note: The
eighth turn must end in the 3 (RUN) position.
5. The doors will lock, then unlock, to confirm that the programming
mode has been activated.
6. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the
procedure over again.
7. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
8. Repeat Step 6 to program each additional remote entry transmitter.
9. Turn the ignition to the 1 (LOCK) position after you have finished
programming all of the remote entry transmitters.
10. The doors will lock, then unlock, to confirm that the programming
mode has been exited.
Illuminated entry
The interior lamps illuminate when the remote entry system is used to
unlock the door(s).
The illuminated entry system will turn off the interior lights if:
• the ignition switch is turned to the 2 (ACCESSORY) position, or
• the remote transmitter lock control is pressed, or
• the doors are locked by key in the door cylinder, or
• the doors are locked using the keypad, or
• after 25 seconds of illumination.
Illuminated exit
• The interior lights will illuminate when the key is removed from the
ignition.
2005 Mercury Mariner (mrn)
Owners Guide (post-2002-fmt)
USA_English (fus)
Locks and Security
83

Mercury 2005 Mercury Mariner Specifications

General

Brand	Mercury
Model	2005 Mercury Mariner
Category	Automobile
Language	English