Mercury 250 EFI - Page 650

LEFT HAND NON-RATCHETING
Page 6B-86 90-884294 OCTOBER 2001
9. Install the bearing carrier into the gear housing backwards to hold the propeller shaft
and the pinion nut adaptor in position.
10. Torque the pinion nut by turning the drive shaft using the drive shaft nut wrench and
torque wrench with the appropriate socket to 70 lb. ft. (95 Nm).
57950
c
a
b
a-Pinion Nut Adaptor (91-61067A2)
b-Drive Shaft Nut Wrench (91-56775)
c-Bearing Carrier (installed backwards)
11. Remove the bearing carrier, pinion nut adaptor and drive shaft nut wrench.
12. Torque the retainer to 100 lb. ft. (135 Nm).
57935
a
a-Drive Shaft Bearing Retainer Wrench (91-43506)
13. Remove the retainer wrench.