Mercury 250 Jet Drive - Install thru-hull fittings and bellows assemblies; Route steering cable; Install tab washer and nut

250 HP JET DRIVE INSTALLATION MANUAL
Page 17
90-10240040 DECEMBER 2003
2. Install thru-hull fittings and bellows assemblies. Tighten securely after pump is secured
in hull.
b
c
c
d
e
a
a-Thru-Hull Fitting, and Bellows Assembly
b-Thru-Hull Fitting and Nut
c-Clamp
d-Bellows
e-Slit Adaptor
3. Route steering cable through the thru-hull fitting and bellows. Route cable through the port
side flange of pump housing. Install nut on cable before routing cable through wear ring.
58142
a
b
a-Shift Cable
b-Wear Ring
4. Install tab washer and nut on cable after guiding through wear ring. Locate tab washer
in tab hole. Coarse cable adjustment is made using these nuts. Do not tighten until after
final steering adjustment is made.
58143
d
c
a
b
a-Tab Hole
b-Nut
c-Tab Washer
d-6.4 mm (0.25 in.)