35
og
FEATURES & CONTROLS
og71
1
Manual Tilting (Fleet Master & Torque Master
Models Only)
If the outboard cannot be tilted using the power trim/tilt switch, the
outboard can be manually tilted.
1 Turn out the manual tilt release valve 3 turns (counterclockwise).
This allows manual tilting of the outboard. Tilt the outboard to the
desired position and tighten the manual tilt release valve.
NOTE: The manual tilt release valve must be tightened before op-
erating the outboard to prevent the outboard from tilting up during
reverse operation.
To Next Page
Loading...
