56
MAINTENANCE
goh121
1
2
b
c
a
omh1
Fuse Replacement
IMPORTANT: Always carry spare SFE 20 AMP fuses.
1 The electric starting circuit is protected from overload by an SFE
20 AMP fuse. If the fuse is blown, the electric starter motor will
not operate. Try to locate and correct the cause of the overload.
If the cause is not found, the fuse may blow again. Replace the
fuse with a fuse of the same rating.
Replace with a new SFE 20 AMP fuse.
ohk12
Corrosion Control Anodes
IMPORTANT: Anodes help protect the metal of the outboard
from galvanic corrosion by sacrificing their metal to be slowly
eroded instead of the outboard metals being eroded. All
anodes require periodic inspection, especially in salt water.
Replace any anodes before they are completely eroded. Never
paint or apply protective coating on the anode as effectiveness
of the anode will be reduced.
2 Your outboard has the following (four) corrosion control
anodes.
a-Two bars, one in each side of the gear case housing above
the anti-ventilation plate.
b-One plate installed under the anti-ventilation plate.
c-One bar across the bottom of the transom bracket assembly.
To Next Page
Loading...
