2C-4 - INSTALLATION - BRAVO DRIVES 90-823225--1 1096
6. Set engine down on stringers and relieve hoist
tension. Disconnect sling from engine lifting eyes
and switch sling to center lifting eye.
72024
a
a - Center Lifting Eye
!
CAUTION
DO NOT use an alignment tool from another man-
ufacturer. Alignment tools other than Quicksilver
Alignment Tool 91-805475A1, may cause improp-
er alignment and damage to gimbal bearing and/
or engine coupler.
!
CAUTION
To avoid damage to gimbal bearing, engine cou-
pler, or alignment tool:
• DO NOT attempt to force alignment tool!
• DO NOT raise or lower engine with alignment tool
inserted (or partially inserted) in gimbal bearing or
engine coupler.
7. Align engine as follows:
a. Attempt to insert solid end of Quicksilver
Alignment Tool through gimbal bearing and
into engine coupler splines. If it will not insert
easily proceed to following.
b. If the tool does not fit, remove it and carefully
raise or lower the from end of the engine, as
necessary, and attempt to insert the align-
ment tool.
c. Repeat step “b” until the alignment tool in-
stalls easily (SLIDES FREELY) all the way
into and out of engine coupler splines.
70013
b
a
a - Alignment Tool (Use Only Quicksilver Alignment Tool
(91-805475A1)
b - Insert This End of Alignment Tool through Gimbal Housing
Assembly
72585
b
c
a
a - Alignment Tool
b - Gimbal Bearing
c - Engine Coupler
To Next Page
Loading...
