5B-16 - MERCARB 2 BARREL CARBURETOR 90-823225--1 1096
3. Remove main metering jets.
72291
b
a
b
a - Main Metering Jets
b - Gaskets (Not Shown)
IMPORTANT: Use care when removing venturi
cluster to prevent damaging brass tubes which
protrude from bottom of cluster. DO NOT RE-
MOVE TUBES. These tubes are permanently
pressed into the venturi cluster and are not re-
placeable.
4. Remove three venturi cluster screws, and care-
fully lift cluster and venturi gasket straight up.
72292
b
a
a - Venturi Cluster Brass Tubes
b - Gasket
5. Using a needle-nose pliers, remove accelerator
pump check ball spring retainer. Turn float bowl
over to remove spring and check ball.
72407
b
a
a - Spring Retainer
b - Spring and Check Ball (Not Shown)
THROTTLE BODY ASSEMBLY
IMPORTANT: Use extreme care when handling
throttle body, so as not to damage throttle valves.
1. Place float bowl assembly upside down. Remove
three throttle body assembly attaching screws
and lockwashers, and remove throttle body and
gasket from float bowl.
72294
b
c
d
a
b
a - Screws
b - Lockwashers (Not Shown)
c - Throttle Body
d - Gasket (Not Shown)
To Next Page
Loading...
