5D-16 - WEBER 4 BARREL CARBURETOR 90-823225--1 1096
6. Remove adaptor/wedge plate (if so equipped)
from manifold and discard old gasket.
7. Place a clean cloth over intake manifold open-
ings.
IMPORTANT: Covering intake manifold prevents
entry of dirt or foreign material through open-
ings.
Installation
1. Place appropriate new gasket on intake man-
ifold.
2. If so equipped, install adaptor or wedge plate, de-
pending on model. Place appropriate new gasket
on top.
3. Install carburetor and throttle bracket with at-
taching hardware. Torque fasteners to 132 lb. in.
(15 N·m).
71173
b
a
a - Throttle Bracket (Not Visible In This View)
b - Attaching Hardware
71172
b
a
a - Throttle Bracket
b - Attaching Hardware
4. Install fuel line. To prevent over-tightening, hold
fuel inlet filter nut with suitable wrench and tight-
en fuel line connector securely.
71173
b
a
a - Fuel Line
b - Fuel Inlet Filter Nut
To Next Page
Loading...
