90-823225--1 10965E-164 - ELECTRONIC FUEL INJECTION (MULTI-PORT AND THROTTLE BODY)
NOTE: If Boat is equipped with Quicksilver Zero Ef-
fort Controls, the throttle cable mounting stud must
be most forward position on throttle lever.
73855
a
a - Position For Zero Effort Controls
3. Connect throttle linkage. Secure cable barrel an-
chor stud with locknut and tighten securely. Se-
cure cable end guide to lever stud. Thread lock-
nut on stud until it contacts end guide.
a
a
74183
74174
a - Throttle Linkage Connections
4. Install flame arrestor to throttle body. Apply Loc-
tite 242 to threads of studs. Install four flame ar-
restor mounting cap nuts. Torque cap nuts to 50
lb. in. (6 N·m).
72790
b
a
a - Flame Arrestor
b - Cap Nuts (4)
Plenum
NOTICE
Refer to “Service Precautions,” in “Repair
Procedures,” BEFORE proceeding.
REMOVAL
1. Remove flame arrestor and throttle body as out-
lined previously.
2. Disconnect MAP sensor electrical connector.
To Next Page
Loading...
