MANIFOLDS AND ELBOWS - 7B-190-823225--1 1096
Torque Specifications
Fastener Location Lb. Ft. N·m
Hose Clamp Securely
Exhaust Elbow
Exhaust Manifold
Sealants
Description Part Number
Quicksilver Perfect Seal 92-34227-1
Removal
!
WARNING
Avoid possible injury or damage to equipment
should wires be accidentally shorted. Discon-
nect BOTH battery cables from battery before
proceeding.
1. Disconnect battery cables from battery.
!
CAUTION
To avoid severe engine damage. Exhaust elbows
and manifolds MUST BE drained to prevent water
(or coolant) from entering combustion chambers
when exhaust elbows are removed.
2. Drain water from manifold and exhaust elbow.
(Refer to SECTION 6A or 6B.)
3. Disconnect exhaust bellows and cooling hoses.
4. Starboard Manifold:
a. Disconnect both shift cables (MCM only).
b. Disconnect instrument harness plug from en-
gine harness, if mounted on exhaust elbow.
c. Remove shift plate assembly from exhaust
elbow (MCM only).
d. Remove bolt holding bracket for Quicksilver
Water Separating Fuel Filter to exhaust man-
ifold.
5. Port Manifold:
a. Remove remote oil filter and bracket.
b. Remove ignition module from exhaust elbow
(if so equipped).
6. Remove exhaust elbow.
7. Remove exhaust manifold fasteners; remove
manifold assembly and discard gaskets.
72695
c
d
e
a
b
f
Stainless Steel Elbow With Restrictor Gasket
a - Exhaust Elbow
b - Bolts (4)
c - Gasket-Seawater Cooled (Aligned As Shown)
d - Exhaust Manifold Assembly
e - Plug
72696
c
d
e
a
b
f
Stainless Steel Elbow With Separator Gasket
a - Exhaust Elbow
b - Bolts (4)
c - Manifold Separator Gasket
d - Exhaust Manifold Assembly
e - Plug
To Next Page
Loading...
