HURTH DOWN ANGLE TRANSMISSION - 8C-2190-823225--1 1096
REVERSING CLUTCH, GEARS AND TAPERED
ROLLER BEARINGS
1. Remove tapered roller bearing from splined end
of input shaft using special tool as follows:
a. Place tool over tapered roller bearing. Ensure
jaws of tool will be pulling on bottom edge of
rollers and NOT on the cage.
27671
b
a
a - Jaws
b - Bottom Edge Of Rollers
b. Tighten jaws onto bearing by turning on
knurled part of tool. Tighten assembly.
27671
c. Pull tapered roller bearing from shaft using
tool as shown.
27672
b
a
a - Hold Tool Stationary
b - Turn Top Nut
To Next Page
Loading...
